Saturday, March 26, 2011

Idea Gifts | Wrapagami



























Lay a button-down shirt flat with the back of the shirt facing up. Slide your gift box inside the shirt.

CLX shirt ht1 wrap 1209 de 99902289 Gift Wrapping Ideas   Wrapagami

Fold the top and bottom of the shirt over the gift. Use a safety pin to secure any excess fabric, if necessary.

CLX shirt ht2 wrap 1209 de 21130948 Gift Wrapping Ideas   Wrapagami

Cross the sleeves so they wrap around the back of the box, then flip the gift right side up.

CLX shirt ht 3 wrap 1209 de 21709645 Gift Wrapping Ideas   Wrapagami

Tie the sleeves into a square knot. If your gift is narrow, you may be able to tie the sleeves into a bow.

CLX shirt ht3 wrap 1209 de 69009855 Gift Wrapping Ideas   Wrapagami

Friday, March 25, 2011

Gift Idea | Embellished Ribbon

This preppy treatment is a ribbon tied onto a loop and threaded belt-style through a second loop.

Thursday, March 24, 2011

DIY Gifts | Butterfly Box and Table Card













Directions:

For box:
1. Begin with a 12 x 12 inch sheet of light green paper. Score a line 3 7/8 inches in from one edge, parallel to the edge, running the length of the paper. Repeat on remaining three sides. This piece will become the box lid.
2. Cut the score lines on two opposing sides of the page up to the center scored square.
3. Stamp each of the four square flaps with a different bird stamp using blue ink.
4. Fold the corner squares in and secure with double-sided tape.
5. Score a second 12 x 12 inch sheet of light green paper 4 inches in on all sides, as in Step 1. Repeat Step 2 and tape box together.
6. Stamp the orange cardstock with various teal and red butterflies, and cut them out with a craft knife or precision scissors.
7. Stamp the gold cardstock with orange butterflies and cut them out. You will need approximately three large butterflies and four small ones in all.
8. Cut 1/4 inch strips of orange cardstock: one 4 inches long, three 3 inches long, and three 2 inches long.
9. Roll the 4 inch strip into an oval ring and attach one short end to a small butterfly. Tape the other short end of the ring to the center of the box.
10. Roll the three 3 inch strips into rings, securing with tape. Attach each one to a large butterfly. Tape the bottoms of the rings to the box, so the large butterflies face each other surrounding the first butterfly.
11. Roll the three 2 inch strips into rings and tape them to three small butterflies. Tape rings to the box, using them to obscure the rings in the center of the box between the large butterflies.

For card:
1. Cut a 7 x 5 inch piece of pastel green cardstock. Stamp a bird in the center using blue ink.
2. Score across the cardstock about 3 1/2 inches from the bottom on both sides of the bird. Use a craft knife to cut out the part of the bird above the score line.
3. Stamp a small butterfly onto gold cardstock using orange ink. Cut out the butterfly with scissors or a craft knife on a cutting mat, and tape it to the end of the wire.
4. Cut a small hole along the fold to the right of the bird and insert the other end of the wire, securing it with tape inside the card. Tip: Use scissors, a thumbtack, or a paper clip to create the hole.

Wednesday, March 23, 2011

DIY Gifts | Zipper brooches
























Supplies:
Fabric marking pen or chalk
Hand-sewing needle
Nonwoven material scrap for pin back (suede, leather, synthetic leather, or felt)
Pin closure
Pins
Ruler
Scissors
Sewing machine
Thread to match zipper tape
Zipper tape, 56 inches (or one 28-inch zipper, separated)

Create flower petals from a zipper
The brooch has two six-petal layers, plus a center swirl. After you cut the zipper up, the parts are swift to baste and sew by machine.

1. Prepare the zipper. You need zipper tape and teeth only. Cut away stops, and remove the slider. Press the zipper tape if it needs it.

2. Segment the zipper. Cut six 4-inch lengths for the larger petals, six 3-inch lengths for the smaller petals, and one 8-inch length for the center.

Wriggle the scissor blades between the teeth to cut the zipper tape.


3. Gather to give the petal shape. Machine-baste close to the long tape edge on a zipper petal length. Pull the bobbin thread to gather slightly (the zipper curls toward the tape edge). Push the gathering to the middle. Repeat for all petals.


Pull the bobbin thread to gather each tape edge.

Tip: Plan the pieces If you don’t use a single zipper tape, you should plan and mark the cutting lines on a separating zipper or multiple shorter zippers. Arrange the cuts so you don’t run short for any pieces.

4. Form and sew the petals. Fold a gathered zipper length in half. Open the fold at the cut ends, and overlap the tape with the zipper teeth to the outside. Pin, or hold in place. Stitch the petal center through the overlapping tape from the cut ends to the petal’s outer tip. Repeat for all remaining petals.




5. Make the flower center. Baste close to the center’s long tape edge. Pull the bobbin thread to gather the center into a spiral. Make the spiral tight at the beginning; loosen the gathers for the outer rings. Tuck the end under and baste in place.


Gather the flower center zipper tape into a spiral.


Assemble the flower, and make it a pin
With some hand-sewing, you’ll build your pin from the petals and center. The finishing touch is a quick pin backing.

1. Join the petals in two layers. Sew the six large petals together, adding one at a time to create a circle. Lap each petal’s base over the next, clockwise or counter-clockwise (it doesn’t matter as long as you’re consistent!). Hand-stitch them together securely. Arrange and sew the six small petals in another circular layer.


Hand-stitch the petals together.

2. Sew the petal layers together. Place the smaller layer over the larger layer. Offset the petals to fan attractively. Pin in place. Secure the petals by hand-sewing through both layers close to the middle.


Arrange the two petal layers into a full flower.

3. Finish the flower, and Add a pin closure. Slipstitch the flower center in the center of the petal layers. To attach the pin and back, cut a 11⁄2-inch circle from the backing fabric. Sew the pin closure to the circle, and then hand-sew the circle to the flower’s bottom petal layer. You can hide your stitches beneath the smaller petal layer and flower center.


Tuesday, March 22, 2011

Diy Gift | Key Chain as Gift Tag






















Add a fun touch to a gift box by using a bright key chain as a tag, attached with big rubber bands in place of ribbon. The recipient will love it, even if it doesn’t go with a bow-wrapped Lexus in the driveway.

Monday, March 21, 2011

Creative Gift Wrap Ideas






















Napkins as Gift Wrap
Got a bottle of wine or champagne to give? Why not wrap it using a new napkin? In fact, wrap a set of six napkins around the bottle and give a duel gift? says you simply need to cinch it at the top with a pretty ribbon. Simple, beautiful and easy.